GENERAL SPECIFICATIONS :
Power supply : bus
Ambient temperature :
Working temp. range : 10°C to 50°C
Storage temp. range : -10°C to 60°C
Maximum humidity : 93%, no moisture
condensation
Bus load :
At rest: 5mA without LEDs, 8mA with
LEDs at nominal 13,8V
During activation: 16mA without LEDs,
20mA with LEDs at nominal 13,8V
Max installation altitude : 2.000 meters.
OUTPUTS :
UP – DN: Up – Down contacts for motor control
Rated current : 3,5A inductive
A bipolar automatic fuse of maximum 6A must be
placed on the mains power.
Contact resistance : 30m
Endurance : min. 100,000 operations
Rated load :
Resistive load (cos = 1)
8A at 230Vac
8A at 30Vdc
Inductive load (cos = 0,4; L/R = 7 ms)
3,5A at 230Vac
3,5A at 30Vdc
Maximum switching power :
Resistive load (cos = 1)
2 UP/DOWN OUTPUTS 230V SHUTTER MODULE WITH POSITIONING
In a Qbus system, motor control (for shutters, screens,…) can be done centrally (from the electrical distribution board) or decentrally (with a module on the bus closeby the motor).
Your custom content goes here. You can add the content for individual product
Related products
The CTD Controller (Patent Pending) is the heart of your QBus system. The Controller controls and supplies power to all Qbus modules connected via the usual two-wire bus: flexible and easy to install. Each controller has an on-board SD memory card on which all actions that happen on the bus are stored. That data can be used by the Qbus EQOmmand software to visualize, predict and optimize energy consumption. Each CTD has a standard USB port to adapt your system to your liking in an easy way. Optionally, each controller can have an Ethernet port via which you can securely communicate with your controller over the internet.
CONTROLLER “MAXI” WITH USB ETHERNET
4 OUTPUTS 0/1-10V ANALOG DIMMER MODULE
The CTD Controller (Patent Pending) is the heart of your QBus system. The Controller controls and supplies power to all Qbus modules connected via the usual two-wire bus: flexible and easy to install. Each controller has an on-board SD memory card on which all actions that happen on the bus are stored. That data can be used by the Qbus EQOmmand software to visualize, predict and optimize energy consumption. Each CTD has a standard USB port to adapt your system to your liking in an easy way. Optionally, each controller can have an Ethernet port via which you can securely communicate with your controller over the internet.
BASIC CONTROLLER
